-->CISCO技术文档－热点帮助-->Sample Configuration

后一页
前一页
Sample Configuration - DLSw SDLC PU 2.1, PU 2.0 Multidrop


RouterA	RouterB
hostname RouterA source-bridge ring-group 100 dlsw local-peer peer-id 1.1.1.11 dlsw remote-peer 0 tcp 1.1.1.12 interface TokenRing0 no ip address ring-speed 16 source-bridge 2564 1 100 source-bridge spanning interface Serial0 ip address 1.1.1.11 255.0.0.0	hostname RouterB source-bridge ring-group 100 dlsw local-peer peer-id 1.1.1.12 dlsw remote-peer 0 tcp 1.1.1.11 interface Serial0 ip address 1.1.1.12 255.0.0.0 interface Serial1 mtu 4400 no ip address encapsulation sdlc no keepalive clockrate 19200 sdlc role primary sdlc vmac 4000.1234.5600 sdlc N1 27200 sdlc address C1 sdlc xid C1 05DCCCC1 sdlc partner 4001.3745.1088 C1 sdlc address C2 xid-poll sdlc xid C2 05DCCCC2 sdlc partner 4001.3745.1088 C2 sdlc dlsw C1 C2

RouterA

RouterB

hostname RouterA
source-bridge ring-group 100
dlsw local-peer peer-id 1.1.1.11
dlsw remote-peer 0 tcp 1.1.1.12


interface TokenRing0
no ip address
ring-speed 16
source-bridge 2564 1 100
source-bridge spanning


interface Serial0
ip address 1.1.1.11 255.0.0.0

hostname RouterB
source-bridge ring-group 100
dlsw local-peer peer-id 1.1.1.12
dlsw remote-peer 0 tcp 1.1.1.11


interface Serial0
ip address 1.1.1.12 255.0.0.0


interface Serial1
mtu 4400
no ip address
encapsulation sdlc
no keepalive
clockrate 19200
sdlc role primary
sdlc vmac 4000.1234.5600
sdlc N1 27200
sdlc address C1
sdlc xid C1 05DCCCC1
sdlc partner 4001.3745.1088 C1
sdlc address C2 xid-poll
sdlc xid C2 05DCCCC2
sdlc partner 4001.3745.1088 C2
sdlc dlsw C1 C2

Notes

This configuration requires Cisco IOS 11.0 or later.
You must use sdlc role primary for multidrop.
In the sdlc address C2 xid-poll command, xid-poll indicates that this PU is a 2.1 device.
The sdlc vmac 4000.1234.5600 statement specifies the MAC address that represents the SDLC devices on the Tpken Ring (LLC) side. The SDLC address if each PU is inserted into the last two bytes of the virtual MAC address.
The sdlc partner 4001.3745.1088 C1 statement specifies the Token Ring station's MAC address.
The sdlc xid C1 05DCCCC1 statement generates the XID F0 T2 for PU 2.0 devices.
The sdlc dlsw C1 C2 statement assigns these PUs to the DLSw+ feature.

后一页
前一页

回首页